Ametek BPS Series Programming Manual Manual do Utilizador descarregar pdf (Página 218)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual

218 Manual P/N 7003-961 Rev AA

Number Message String Cause Remedy

27 “Frequency error” Frequency is out of

allowable range.

Indicates a problem with

programmable controller.

28 “Phase error” Incorrect phase

29 “DC component

exceeds limit”

The waveform

selected contains a

DC offset that

exceeds the AC

mode capability.

Select AC+DC mode.

30 “Amplifier fault” Amplifier fault. Contact customer service.

31 “Warning negative

power near limit”

Approaching limit on

the amount of power

that can be fed back

into the supply by an

active load. This is a

warning only.

Stop increasing power feedback into

the power supply. Typically occurs

when using AC inverters. If power

increases further, an error 32 will be

generated.

32 “Negative power fault” Too much power fed

back. Power source

output disconnected.

Reduce the amount of power being

fed back into the power source.

Table 8-4 : Error Messages

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 224 225 226

Sem comentários

Ametek BPS Series Programming Manual Manual do Utilizador Página 218