Ametek DCS-E 1kW Series Programming Manual Manual do Utilizador descarregar pdf (Página 19)

DLM-E Series and DCS-E Series Isolated Analog Programmer Operation

2.3 Remote Programming Configuration

2.3.1 Voltage Source Programming of Output Voltage

SW1 Switch Settings

SW1-1 ON (1)= 0–5V

SW1-1 OFF (0)= 0–10V

291213 1

Set up for voltage source programming of the output voltage as follows:

1. Set SW1-1, V PROG, to ON (1) for 0-5VDC programming range.

2. Set SW1-1, V PROG, to OFF (0) for 0-10VDC programming range.

3. Connect the external programming voltage source to the ISOLATED ANALOG

PROGRAMMER connector, J4, with positive to Pin-9 and negative to Pin-12.

4. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

5. Program the other parameters to the desired limit values.

M51A Option 2-7

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Sem comentários

Ametek DCS-E 1kW Series Programming Manual Manual do Utilizador Página 19