Ametek DCS-E 1kW Series Programming Manual Manual do Utilizador descarregar pdf (Página 21)

DLM-E Series and DCS-E Series Isolated Analog Programmer Operation

2.3.3 Voltage Source Programming of OVP

SW1 Switch Settings

SW1-3 ON (1) = 0–5V

SW1-3 OFF(0) = 0–10V

2361213 1

1416

Set up for voltage source programming of OVP as follows:

1. Set SW1-3, OVP PROG, to ON (1) for 0-5VDC programming range.

2. Set SW1-3, OVP PROG, to OFF (0) for 0-10VDC programming range.

3. Connect the external programming voltage source to the ISOLATED ANALOG

PROGRAMMER connector, J4, with positive to Pin-5 and negative to Pin-12.

4. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

5. Connect Pin 16, OVP RESISTANCE PROGRAMMING OUTPUT, of the ISOLATED

ANALOG PROGRAMMER connector, J4, to Pin 6 to disable the default OVP

programming connection.

6. Program the other parameters to the desired limit values.

M51A Option 2-9

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sem comentários

Ametek DCS-E 1kW Series Programming Manual Manual do Utilizador Página 21