Ametek 1995L Micro-Set PLS Manual do Utilizador descarregar pdf (Página 13)

Installation and Maintenance Manual

Chapter 3: Programming

3.10: Clear an Existing Setpoint

A) Unit must be in the Program mode.

B) Depress .

C) Depress or key until setpoint to be cleared is on the display.

D) Depress the key. Upon depression of the key, the setpoint on

the display after Step C is deleted.

E) This keypad sequence must be completed once to clear an ON setpoint and a second time to

clear the OFF setpoint. See Section 3.9: Setpoints

CIR#

CIR ON

(Output to be Cleared) ENT

CIR OFF

CLR SETCLR SET

3.11: Clear All Setpoints

There are two methods of clearing all setpoints. This is accomplished as follows:

A) Unit must be in the Program mode.

B) To clear all of the setpoints in the active program, depress: .

The active program is the program currently selected using Code 771. See Section 3.7:

Setpoint Formula.

-OR-

C) To clear all the setpoints in all programs, depress: .

CIR#

ENT

CIR#

NOTE: CIR# 91 and CIR# 391 only clear out programmed setpoints. They do not clear out Linear

Speed ramps or change circuits that have been selected as Linear Speed; however, they will

clear the setpoints programmed in these circuits.

3.12: Setpoint Availability

Every 1995 PLS has a limit on the number of setpoints that can be stored in memory. On units with the

Multiprogram option, refer to Section 3.7: Setpoint Formula to calculate the maximum amount of

setpoints available.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Sem comentários

Ametek 1995L Micro-Set PLS Manual do Utilizador Página 13