
Load Module Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 115
5.6
CALIBRATION SCPI COMMANDS
CAUTION
Before attempting to execute any of the Load calibration commands, follow the calibration
procedures in the ReFlex Power™ Operation Manual (M380056-01), Active Loads
Section. If calibration is not performed properly, functional problems could arise,
preventing the ReFlex Power™ Load(s) from operating properly
.
Qualified personnel who
are appropriately trained to deal with attendant hazards must perform calibration.
5.6.1 CALIBRATION
SCPI
C
OMMAND
S
UMMARY
CALibrate<n>
:CALPOTS
:GAIN
:START
:CURRent <NRf>
:CALCulate
:GAIN?
:OFFSet?
:INITial
:CURRent <NRf>
:CURRent?
:CURRent
:PROTection <NRf>
:PROTection?
:POWer
:PROTection <NRf>
:PROTection?
:RESistance <NRf>
:RESistance?
:STATE <bool>
:STATE?
:UNDERVOLTage
:PROTection <NRf>
:PROTection? :VOLTage
:PROTection <NRf>
:PROTection?
:INPut
:CURRent
:COUNTS <NRi>
:CALCulate
:FIVEPOINT <1-5> <NRf>
:RANGE <bool>
:CURRent <1-2> <NRf>
:CONDuctance
:COUNTS <NRi>
:CALCulate
Comentários a estes Manuais